|
Enduro Engine - 2 stroke Cylinder, Piston, Tranny, Bearings, Clutch, Pipes & Silencers, etc. |
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
assembly
2 questions, 1] Do you apply assembly lube on the wrist pin rod bearing and or any other area?2] How much lube,pre-mix I assume,is the proper amount for top-end assembly? I have done this before,but for the sake of sounding stupid I've never asked.Any input would be great.Thanks in advance!!!
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Moto tas reed assembly | Knobbiethrower | Enduro Engine - 2 stroke | 3 | 09-23-2008 02:56 AM |