|
Enduro Engine - 2 stroke Cylinder, Piston, Tranny, Bearings, Clutch, Pipes & Silencers, etc. |
|
Thread Tools | Display Modes |
#11
|
|||
|
|||
well ive had a little win i got some bang. not much but enough for me to not burn it. @Gasser Nate that allen bolt was the ticket. got quite a bit of fluid out from that, mainly oily. drained that flushed with staight fuel(syringe squirt back up) then nothing in carby bowl, aerostart and bang she went. i have to wait till tomorrow to check and see if sparking still an issue as still wouldnt run, my fuel is over 8 weeks old so could be contibuting and not 100% if carby is flooding although im inclinded to discount that as did a full carby clean and set float. going to get some new fuel but b4 putting that in going to make sure it fires a few time on the earostart. i havent pulled the flywheel as yet but everything lines up with the sensor and flywheel with TDC so still possible for timing out but dont think so
thx guys |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
wont start GG 04 450 | chaddlez | Enduro Engine 4 stroke (including EFI & Exhaust) | 9 | 03-26-2016 01:12 PM |
400 fse wont tick over | Ignas | Enduro Engine 4 stroke (including EFI & Exhaust) | 7 | 01-01-2015 04:51 PM |
Why wont it run? Please help | fastisbetter | Enduro Engine 4 stroke (including EFI & Exhaust) | 6 | 12-26-2014 08:34 PM |
my first gas gas wont start? | Southuist | Enduro Engine - 2 stroke | 6 | 03-14-2014 09:59 AM |
02 EC 300 wont start | GENO 300 | Enduro Engine - 2 stroke | 0 | 09-21-2009 10:02 PM |