|
Enduro Engine - 2 stroke Cylinder, Piston, Tranny, Bearings, Clutch, Pipes & Silencers, etc. |
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Re-sleeving the 2 stroke barrel
Has anyone re-sleeved their barrel on the 2 stroke, if so what problems have you had and is it better than renicoseal
|
#2
|
|||
|
|||
Quote:
'Re-Nikasil' and nikasil has numerous benefits over a steel sleeve, heat dissipation, very low wear, better oil retention allowance of closer tolerances etc. Better off just getting it plated. Mine is away, I think it's the first time it's been done and was only 0.03mm oversize!
__________________
2006 EC300 Enduro - Ignitech CDI - 38/NECW#2/165 FMF gnarly, FMF shorty, .50 front 5.7 rear 2016 RM-Z450 |
#3
|
||||
|
||||
80s technology. Get it replated. They can fix most damage before plating. Heat transfer and wear is much worse with a sleeve.
__________________
'07 EC300 GG '14 TXT250 GG '? 496 CPI Cheetah RZ/RGV hybrid '22 765 Street Triple RS '21 XTrainer '69 Stinger T125 Suzuki '23 TRS 250RR (it's a Trials thing) |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
barrel ec 300 | Olliesherman | Enduro Engine - 2 stroke | 9 | 06-20-2016 01:36 PM |
Gasgas ec300 cylinder/barrel | Ec300stav | "Wanted to Buy" & "Want To Trade" | 3 | 10-08-2015 03:40 PM |
barrel ec 250 | hippygary | Enduro Engine - 2 stroke | 1 | 07-01-2014 03:46 PM |
barrel replating | gassergrant | United Kingdom | 5 | 12-02-2013 06:08 AM |
help please ref connections on barrel | merlin1 | Enduro Engine - 2 stroke | 5 | 05-14-2013 03:47 PM |