|
General Discussions & Announcements General Announcements, General Questions, e.g. What bike do I buy?, etc. |
|
Thread Tools | Display Modes |
#1
|
||||
|
||||
Shift lever crossover
Any know a crossover for the shift lever?
TKS |
#2
|
||||
|
||||
Hammerhead Designs makes one and X-Fun. I think the X-Fun needs to be sourced overseas, but the Hammerhead can be bought from them directly or from GoFasters.
__________________
2004 GasGas DE250 |
#3
|
||||
|
||||
tmv makes one also and they are in the new 2010 parts unlimited book. priced write 39.95 retail
|
#4
|
||||
|
||||
RMZ of the 04 or 05 should fit as well. Stock is about .5 inch longer too.
__________________
2002 Gasgas EC250 (gone not forgotten) 2012 Ktm 300xc 2001 Gasgas EC300 Lifes journey is not to arrive safely at the grave in a well preserved body, But rather to skid in sideways totally worn out shouting holy cow what a ride !!!! |
#5
|
||||
|
||||
Quote:
http://www.parts-unlimited.com/produ...roductId=51174
__________________
2004 GasGas DE250 |
#6
|
||||
|
||||
Quote:
|
#7
|
||||
|
||||
I'll keep that in mind when and if I break my new Hammerhead.
__________________
2004 GasGas DE250 |
#8
|
||||
|
||||
the tmv one is longer and a slightly different bend. not a bad thing.
|
#9
|
||||
|
||||
I picked up a YZ 250-f steel Moose shifter from the local shop to try out and see if it fits
It looks close?? I'll post the results. But, nice to know the RMZ shifter will work....that's good info |
#10
|
||||
|
||||
I'm running the TMV shifter on my bike. It is softer than stock and will bend fairly easy but the tip is much better than stock and the shifter stays tight on the shift shaft so I'm happy with it.
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Shift Lever | PEB | Enduro Chassis & Body | 6 | 09-29-2009 05:45 PM |
Longer shift lever for the FSE??? | McGuiver | Enduro Engine 4 stroke (including EFI & Exhaust) | 7 | 01-08-2009 08:04 PM |