|
Enduro Intake/Carburetion - 2 stroke Jetting, Reeds, Air Filters, etc. |
|
Thread Tools | Display Modes |
#1
|
||||
|
||||
Starting point for Western Washington?
Hi, all-
I am just getting my 2002 XC300 ready to ride, and wanted to run my jetting past the "experts." I bought the bike last month and spent the last few weeks sorting out some issues, but now I'm about ready to ride it in anger. A couple of spins in front of the house do not provide accurate jetting, but it does upset the neighbors a bit. Here's my current set up- 50:1 Premium pump/Amsoil Dominator Carb is stock, as far as I can tell. No obvious modifications to any external points or functions. Needle- Don't know. The only markings are "CC" (maybe GG?). Nothing else indicated. Clip- was on second from top (lean), now in middle (it's what I do to set baseline on my other bikes) Main- 170 Pilot- 38 AS- Now at 1.5, was at .5 Any suggestions from those who ride Walker Valley, Tahuya, and Capitol Forest? I don't mind buying a handful of brass, but I do want to make sure I am going in the right direction. I don't want to make any broad generalizations or assumptions, but previous experience with this bike in my riding area is preferred. The main reason to question the current jetting is that it's a former California bike, and I think it was set up for hot weather high-country riding. The piston looked kind of lean (lots of carbon), and I want to make sure I don't melt anything my first time out. |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Tank cracked at mounting point | Bailey28 | Enduro Chassis & Body | 8 | 05-15-2013 01:47 AM |
SG10 boots - how to fix a pressure point? | Eric K | Enduro Other... | 6 | 11-09-2011 02:09 PM |
Clutch Friction Point | mcnut | Enduro Engine - 2 stroke | 13 | 05-09-2011 08:56 PM |
western nebraska on a '98 Pampera | mudwasp | Ride Reports | 0 | 02-13-2011 10:50 PM |
What is the point of the bolt on the side of the head? | Motarded1 | Enduro Engine 4 stroke (including EFI & Exhaust) | 1 | 02-03-2009 06:17 PM |