|
General Discussions & Announcements General Announcements, General Questions, e.g. What bike do I buy?, etc. |
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
2010 clutch install..?
hi all. I am installing my stock clutch after using a rekluse. Does anyone know the correct plate order and have a parts diagram?
|
#2
|
||||
|
||||
Not sure on 2010 but my manual shows 8 fibers 7 steel
Stoby |
#3
|
||||
|
||||
You should start with a fiber plate and end with a fiber plate. There should be a steel between each fiber plate. It's that simple.
__________________
2018 EC 300 |
#4
|
|||
|
|||
Thanks, its more the location of the washers on the basket I am confused with, but looks like ill get there, ta for the advise
|
#5
|
||||
|
||||
if hub and basket are removed:
in this order spacer washer(thrust washer) 2 needle bearings and sleeve basket spacer washer(thrust washer) hub lock washer nut - both spacer washers should be the same thickness on 2010 i believe then plates pressure plate springs cup washers screws if throwout bearing was removed: (from inside out) pushrod holder throwout bearing throwout washer pressure plate circlip
__________________
07 ec300 was 00 xc200 now a 00 xc300. now parting out. 99 ec300 (now a pile of parts which are for sale) Stainless Cycle - Motorcycle Bolt Kits www.stainlesscycle.com Last edited by stainlesscycle; 08-12-2011 at 01:17 PM. |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Rekluse exp install tips from the guys that know! | nambo-trev | Enduro Engine - 2 stroke | 12 | 08-02-2011 10:19 PM |
dyna ring install ? | jhendr3702 | General Discussions & Announcements | 13 | 02-17-2011 03:29 PM |
Scorpion Rad Frames-2010/11 EC-Install Pics | JP4 | Enduro Chassis & Body | 4 | 02-07-2011 07:33 AM |
top end install help!!!! | rdbandkab | Enduro Engine - 2 stroke | 12 | 01-19-2007 04:20 PM |
Tech Article : Rekluse Auto Clutch Install | webmaster | Enduro Engine - 2 stroke | 0 | 07-24-2006 10:14 PM |