|
Enduro Chassis & Body Enduro Frame, Plastic, Brakes, Bars, Controls, wheels, tires, sprockets & gearing. |
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
2 finger clutch lever
Does anyone know of a 2-finger after-market clutch lever? I'd like to keep my stock one un-altered as a replacement or in case I end up not liking a 2 finger lever.
When I last ordered some parts from GoFasters they mentioned ASB (if that's the right name) might be making some. |
#2
|
|||
|
|||
I have a shorty clutch lever I purchased from my local GasGas Dealer.
It's an original part you should readily be able to get....
__________________
"It's Nature that Brings out the Madness" GasGas FSR450 07' |
#3
|
|||
|
|||
i run a longer lever and just slide the resivor up the bar about 2.5 inches
so you only use 1 or 2 fingers on the lever and its makes it a heap lighter too |
#4
|
||||
|
||||
Doesn't the lever hit the collar on the grip?
__________________
2004 GasGas DE250 |
#5
|
|||
|
|||
Quote:
that doesn work to well if you ride tight trees and have to cut the bars down and are running bark busters. I ordered a shorty lever from the local gasser trials dealer, it turned out to be the same length as the stock lever. Don't know if your going to find anything much shorter |
#6
|
||||
|
||||
The trials levers come in 2 lengths and are available aftermarket. - Ken
|
#7
|
|||
|
|||
No all you do is just cut a small semi-circle out of the the grip
|
#8
|
||||
|
||||
Simplicity is bliss isn't it!
__________________
2004 GasGas DE250 |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Folding clutch lever | sen480 | General Discussions & Announcements | 4 | 01-16-2010 10:02 AM |
clutch lever to big | rupecopp | Enduro Chassis & Body | 3 | 06-09-2008 05:15 AM |
$ 30 for a clutch lever ? | fasternat | Enduro Chassis & Body | 1 | 09-21-2007 12:01 AM |
Clutch Lever Bushings | PEB | Enduro Chassis & Body | 1 | 05-27-2007 03:02 PM |