![]() |
|
Trials Engine Cylinder, Piston, Tranny, Bearings, Clutch, Pipes & Silencers, etc. |
![]() |
|
Thread Tools | Display Modes |
|
#1
|
|||
|
|||
![]()
I have a 2001 200 txt for a spare, buddy bike. Bought it with a pretty decent top end rattle that my last 200 did not have. Previous owner said it?s been like this for the 6 years he had it, and I have no reason to disbelieve him. Lots of compression, more than my last one, and this one starts if you so much as look at it.....first kick always, hot or cold.
I want the rattle gone. It has the B piston. So I would want to very very lightly hone it, and another B piston just in case the pin bore is big, new rings just because, and a new wrist pin bearing. Sounds top end, not bottom but posting all this in hopes others here might offer guidance and some info on where to get the above parts. Our local gasgas fellow only has an A piston. Thanks in advance. Love this little bike, even against my montesa 300rr sold my last 200 to a buddy because he begged me.......searched for another ever since! Steve Last edited by Howsounder; 04-25-2021 at 04:39 PM. Reason: Spelling |
#2
|
||||
|
||||
![]()
My 2000 had top rattles in a way that the 2001 the seller also had didn't. Wasn't too bad so bought the 2000. After a while I got it measured and he said buy the same B piston. It was unworn and round.
Was a little better but the rattle came back after a bit. I think the piston has enough taper that it rattles. Never caused a problem.
__________________
'07 EC300 GG '14 TXT250 GG '? 496 CPI Cheetah RZ/RGV hybrid '22 765 Street Triple RS '21 XTrainer '69 Stinger T125 Suzuki '23 TRS 250RR (it's a Trials thing) |
#3
|
|||
|
|||
![]()
Any idea where to get parts? I want some spares just in case
Steve |
#4
|
||||
|
||||
![]()
I used local guy in NZ, can't advise for, I'm assuming Northern hemisphere
__________________
'07 EC300 GG '14 TXT250 GG '? 496 CPI Cheetah RZ/RGV hybrid '22 765 Street Triple RS '21 XTrainer '69 Stinger T125 Suzuki '23 TRS 250RR (it's a Trials thing) |
![]() |
Thread Tools | |
Display Modes | |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
Is this the dreaded PV rattle?? | Martin-EC300 | Enduro Engine - 2 stroke | 13 | 04-18-2016 07:59 AM |
Exhaust Rattle | swazi_matt | Enduro Engine - 2 stroke | 14 | 08-12-2012 12:56 AM |
rattle | Rabbitist | General Discussions & Announcements | 4 | 09-07-2011 08:10 PM |
200 powervalve rattle? | noobi | Enduro Engine - 2 stroke | 3 | 04-08-2010 07:25 AM |
clutch rattle? | jostby | Enduro Engine - 2 stroke | 0 | 02-25-2007 05:01 PM |