|
|
|||||||
| Enduro Engine 4 stroke (including EFI & Exhaust) 4 stroke engine, EFI, and exhaust discussion |
 |
|
|
Thread Tools | Display Modes |
|
#1
10-09-2012, 02:09 PM
|
|||
|
|||
head gasket blown out
Hallo,
on my FSE 515, the head gasket has blown out. Will repair it and removed first the upper head cover. I wanted to find out the marks for adjusting the camshaft operating. Found the marks on the camshaft-sprokets but not on the flyweel. Didn?t find a manual in www to answer following questions: 1. marks or how do I find the correct position of flywheel/camshafts 2. torque of the head bolts 3. valve clearence Greetings from Germany and Thank You 
|
|
#2
11-02-2012, 01:50 PM
|
|||
|
|||
|
Hallo, rebuilt it now. No marks on flyweel. Had to mark it by myself by using a special indicator at piston on top. Reduced the compression ratio to provide blown head gasget. Torque head bolt 5 mkp and valve clearence 15/20.
Greetings Thomas
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| 97 blew the head gasket? | Cruiser | General Discussions & Announcements | 11 | 08-08-2011 09:40 PM |
| Blown head gasket | Jakobi | Enduro Engine - 2 stroke | 5 | 08-07-2011 09:28 PM |
| Head Gasket/O-ring replacement-anything special? | husley | Enduro Engine - 2 stroke | 5 | 08-06-2011 09:28 PM |
| Radiator / head gasket blown? | GavGav | Enduro Engine 4 stroke (including EFI & Exhaust) | 3 | 12-05-2008 10:35 PM |
| Head-gasket O-Ring question | FFRDave | Enduro Engine - 2 stroke | 5 | 01-12-2008 09:56 AM |
Linear Mode
