|
|
|||||||
| Enduro Engine - 2 stroke Cylinder, Piston, Tranny, Bearings, Clutch, Pipes & Silencers, etc. |
|
|
Thread Tools | Display Modes |
|
#1
05-10-2018, 05:14 AM
|
|||
|
|||
SM 125 clutch problem
So i recently went to switch the front sprocket on my gas gas sm 125 halley 2009 and by mistake pressed the clutch lever while the slave cylinder was off.
Some oil seeped out and i put it back together and have tried to bleed the system multiple times, reverse bleed with a syringe, new oil. Nothing... the clutch doesnt work at all. It feels like normal and has good pressure when i press the lever but it still won't work. I drove it the same day and have been the past 3 weeks. (its the same clutch as in an ec 125 and it uses mineral oil) Don't know what im supposed to do right now, any help is appreciated. 
|
| Tags |
| 125, clutch, not working |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Clutch problem :) | adriano.ro | Enduro Engine - 2 stroke | 2 | 11-17-2016 10:03 AM |
| 01 ec125 clutch problem | michalt95 | Enduro Engine - 2 stroke | 19 | 04-16-2014 08:45 PM |
| EC 250 clutch problem | BluegassXCR | Enduro Engine - 2 stroke | 0 | 07-22-2011 08:27 PM |
| 450 Clutch problem | trxpeter | Enduro Engine 4 stroke (including EFI & Exhaust) | 4 | 09-03-2010 12:38 AM |
| 450 Clutch problem | mike989 | Enduro Engine 4 stroke (including EFI & Exhaust) | 17 | 01-02-2008 08:54 AM |
Threaded Mode