|
Enduro Intake/Carburetion - 2 stroke Jetting, Reeds, Air Filters, etc. |
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Reed Help
Anyone help with part numbers for replacement reeds for this reed block? It is off a 2011 EC 200 Six Days. I'm guessing the previous owner must have switched out the Vforce setup? Seems all the Boyesen reeds I have found have three screw holes and these only have two.
|
#2
|
|||
|
|||
no help on part numbers, but I believe all 2011 200's came with boyesson reeds
__________________
2011 GasGas ec300R 2011 GasGas ec200 Six Days |
#3
|
|||
|
|||
After a few calls and emails to Boyesen I found the correct replacement reeds for reed block with two screws is PSR-115 (dual stage carbon) or RL93 (dual stage fiber)
|
#4
|
|||
|
|||
What are the pros and cons regarding the carbon vs. fiber reeds?
|
#5
|
||||
|
||||
I have been running the carbon reeds [LT] for about a year now.
The work great, both the 250 & 300 have great throttle response and very crisp off bottom. Seat of the pants feel is that the response is better than the Pro Series reeds that I replaced. They come in two types, LT & HT LT=Low tension [low RPM use. ie; woods and single track] HT=High Tension [prolonged high RPM use. ie;MX or road use]
__________________
2003 GG 300EC/DE [Ohlins] 2001 GG 250XCSOLD |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Reed | Rabbitist | Enduro Engine - 2 stroke | 3 | 03-23-2012 11:09 AM |
Reed Advice PLEASE | jriley43 | Enduro Intake/Carburetion - 2 stroke | 1 | 05-19-2009 07:50 AM |
Reed Spacer for EC 250 | GG27 | Enduro Engine - 2 stroke | 4 | 03-28-2009 12:59 AM |
Another Reed Question | dave948 | Enduro Intake/Carburetion - 2 stroke | 1 | 03-12-2009 01:57 PM |
reed question | jostby | Enduro Engine - 2 stroke | 4 | 12-16-2006 08:21 PM |