GasGas Riders Club Forum  

Go Back   GasGas Riders Club Forum > GasGas Enduro Technical Forums > Enduro Engine - 2 stroke

Enduro Engine - 2 stroke Cylinder, Piston, Tranny, Bearings, Clutch, Pipes & Silencers, etc.


Reply
 
Thread Tools Display Modes
  #1  
Old 07-22-2011, 08:27 PM
BluegassXCR BluegassXCR is offline
Senior Member
 
Join Date: Jun 2011
Posts: 107
Default EC 250 clutch problem

Well after looking at the posts on here....

My clutch was in bad need of replacement....dragging BAD....from the PO....

I put a 95ish CR250 clutch in and stood it back up and the clutch feels like a brake....so I took the metals out and used the originals and it still felt like thatbut worked(a very little).....

so what is the cure....

little baffled....I read about a different washer but dont really understand what and where it goes....


Reply With Quote


Reply



Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off


Similar Threads
Thread Thread Starter Forum Replies Last Post
450 Clutch problem trxpeter Enduro Engine 4 stroke (including EFI & Exhaust) 4 09-03-2010 12:38 AM
Clutch problem sticky? dank General Discussions & Announcements 16 05-26-2010 01:20 PM
also an ongoing clutch problem...... dank Enduro Engine - 2 stroke 2 05-19-2010 01:24 PM
ec300 clutch problem dirtjunky_uk Enduro Engine - 2 stroke 13 02-27-2009 08:08 AM
450 Clutch problem mike989 Enduro Engine 4 stroke (including EFI & Exhaust) 17 01-02-2008 08:54 AM




All times are GMT -5. The time now is 07:04 PM.


Powered by vBulletin® Version 3.8.6
Copyright ©2000 - 2019, Jelsoft Enterprises Ltd.
Copyright 2009 - GasGasRider.org