|
Enduro Electrical & Wiring Lighting, Ignition, Wiring, Plugs, etc. |
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
DIY rewiring for higher wattage
I have a 2k ignition and was thinking I may want more power. I also have an XR650R and did a rewire myself thanks to help all over the net, but haven't seen any way to do it on the GG. I have not even looked in there to see what room we have, but I assume you do. Has anyone done this? I may have to find a doner old ignition to play with, anyone want to help? Will of course share what I find. I am sure someone on here is better than me, but so far no one has stepped up.
__________________
2006 EC300, 2000 XR650R, 2003 EC250, 2001 EC200 (OK, the last two are really my sons). |
#2
|
||||
|
||||
This thread has the most information on this
subject that I can remember being posted to GGriders.org http://www.gasgasrider.org/forum/showthread.php?t=1859 Links to floating the ground and doing a re-wire of the stator. Since you did your XR650R. I'd say you have the skills to duplicate that with your 2K2. I did the floating ground mod to my 2K3, but, did not re-wire it for more wattage or voltage. Unless you have the wire and the time. It might be easier to buy one from TrailTech already soup'd up. then again, I am pretty lazy. Jeff |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
higher altitude jetting | mike989 | Enduro Intake/Carburetion - 2 stroke | 5 | 06-17-2010 04:39 PM |
Higher pressure radiator caps | Skidad | Enduro Engine - 2 stroke | 5 | 11-03-2008 03:26 PM |