|
Enduro Engine - 2 stroke Cylinder, Piston, Tranny, Bearings, Clutch, Pipes & Silencers, etc. |
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Transmission bearing
Hi
I am rebuilding the bottom end and got a question about transmission bearings for my EC 300 -03. When I took it apart I noticed that bearing ME25636058 (SHIFT BEARING 6305) is modified. The inner ring is lathed axially, just a tenth or two of a mm. Is this necessary or can I replace with a standard bearing? Sorry for no pic, I have left the bearings at an local dealer. |
#2
|
||||
|
||||
That is really strange. I cant imagine trying to machine the inner or outer race of a bearing.
I would measure the shaft OD and bearing OD and then go find the correct bearing. |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Transmission ec 300 | gumby | "Wanted to Buy" & "Want To Trade" | 10 | 11-02-2014 09:52 PM |
ec 300 transmission oil | jetfish | Enduro Engine - 2 stroke | 32 | 10-27-2010 05:00 AM |
transmission oil on ec250 | twibs | Enduro Engine - 2 stroke | 1 | 03-15-2008 09:13 AM |
No oil in Transmission | RPB111 | Enduro Engine - 2 stroke | 5 | 03-17-2007 08:49 AM |