Nikasil plating

[Rabbitist]

Can anyone from the uk please reccomend a good place (possibly lincolnshire) to get my barrel done thanks luke

[savage sausage]

Originally Posted by Rabbitist

Can anyone from the uk please reccomend a good place (possibly lincolnshire) to get my barrel done thanks luke

I have not used either of these companies . am just trying to offer some suggestions

How about BDK engineering which is based in norfolk

Try Graham File who has now taken over some of stan stephens tuning and services

Motrac racing

[Rabbitist]

Thanks for that I have been in contact with langcourt and it is going to cost me 200 quid for a couple of noggins missing round the ports welded and re bored then nikasil plated.. Does this sound about the right price? Also how much are new barrels?

[hannesd]

Originally Posted by Rabbitist

Thanks for that I have been in contact with langcourt and it is going to cost me 200 quid for a couple of noggins missing round the ports welded and re bored then nikasil plated.. Does this sound about the right price? Also how much are new barrels?

that's a very decent price to me!
i paid about 300 pounds just for plating, but then again, it did get shipped from belgium to the gassers factory in spain!!

[savage sausage]

Originally Posted by Rabbitist

Thanks for that I have been in contact with langcourt and it is going to cost me 200 quid for a couple of noggins missing round the ports welded and re bored then nikasil plated.. Does this sound about the right price? Also how much are new barrels?

If I recall you were looking for another engine at one point
Have a look on ebay germany I've seen a 300cc barrel conversion

http://www.ebay.de/itm/DEMO-Zylinder...item3a62e0077f

[savage sausage]

or this

http://www.ebay.de/itm/Gas-Gas-Austa...item3a62d7e238

[Rabbitist]

Barrel should be back from langcourt tomorrow