|
General Discussions & Announcements General Announcements, General Questions, e.g. What bike do I buy?, etc. |
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Power valves not closing EC 125
Anyone know why the power valves doesnt retract on the EC 125? It is not same as the 300 so keep that in mind.
I have attached a link where you can see how they close and not. When I open them fully, they dont retract, but if you give it just a slightest push, it goes back. Later in the video you can see that when I open them just a tiny bit, they close. So to conclude, when opening fully, they dont retract. When opening a tiny bit, they do. https://streamable.com/ya90za Thanks in advance |
#2
|
||||
|
||||
It is usually carbon deposits jammed in the bore/valves and the little tracks they slide in
__________________
Back on a gassy! 2018 EC300! 🤘 Txt 280 07 to make me feel like a gumby again |
#3
|
|||
|
|||
Okey thanks for the answer!
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
2018 XC300- How do I get power valves out??? | BMG | Enduro Engine - 2 stroke | 3 | 10-08-2023 03:30 AM |
Not closing!!! | GASGASCWB | Enduro Product Announcements | 0 | 06-26-2019 04:18 PM |
DIY adjustable power valves | Harry | Enduro Engine - 2 stroke | 0 | 04-01-2018 05:22 PM |
Power valves after 920 miles | gasgasman | Enduro Engine - 2 stroke | 9 | 02-05-2016 08:55 AM |
Gas Gas 125 power valves | geoffg | Enduro Engine - 2 stroke | 8 | 10-28-2010 01:23 PM |