|
Enduro Chassis & Body Enduro Frame, Plastic, Brakes, Bars, Controls, wheels, tires, sprockets & gearing. |
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
question on axle during bearing change
hello
Im in the middle of swapping the rear wheel bearings, I tried to make a note of everything as I was taking it apart so it will all go back together properly only one thing Im not sure on, when the collar came out (the bit the axle goes through that sits between the bearings) I saw it has groves at one end but not the other but as this fell out during the bearing removal im not sure what end the groves were at so does it matter? thanks si |
#2
|
||||
|
||||
Quote:
__________________
Anders "So you know, that you're over the hill when your mind makes a promise that your body can't fill" (Little Feat: Old Folks Boogie) 2015 EC200 Racing: TE bars, Rekluse Core Exp 3.0, 38mm Lectron & Ohlins S3 steering damper 2006 EC200: 2011 plastics, Rekluse Z-Start, revalved KYB forks & Scotts steering damper 1998 Bimota Supermono 1986 Duc Mille S2 1975 Guzzi sidecar hack 1961 Morini Corsaro 125 etc |
#3
|
|||
|
|||
Quote:
thanks I didnt think it would but thought best to check! |
#4
|
||||
|
||||
If I remember correctly the spacer between the bearing goes one way. Can't tell you which way, if its wrong the bearings will bind.
|
#5
|
|||
|
|||
I think your talking about the small spacer that's like a washer that goes between the big and little bearing, I was talking about the tube as it were that goes between the left hand and right hand side bearings if that makes sense!
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Wild axle bearing carrier crossover | pete8 | Other GasGas Bikes/Quads | 0 | 03-12-2013 05:10 PM |
Quick swingarm/linkage bearing change question | motogroove | Enduro Suspension | 6 | 05-16-2011 12:58 PM |
Fr axle question | Cruiser | General Discussions & Announcements | 2 | 04-18-2008 10:07 AM |
MC65 rear wheel bearing change | bergerhag | Enduro Chassis & Body | 0 | 03-12-2008 03:16 PM |
Swingarm axle question??? | ktmguy23 | Enduro Chassis & Body | 12 | 04-06-2007 11:54 AM |