|
Enduro Chassis & Body Enduro Frame, Plastic, Brakes, Bars, Controls, wheels, tires, sprockets & gearing. |
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Gear Lever Cross Over
Hey all,
The spline on my gear shifter is flogged out, does anyone know if they cross to a Yamaha or anything? I'd like to grab something locally if I can, seen a few anodized ones that look good in shops but didn't have my shifter in hand to compare. BTW, after reading around on the forum about carbs etc I ordered a N3EG to replace my N1EH. The difference is unreal, so clean and crisp, no rich bogging coming out of tight woods and onto a straight. Tail pipe is clean as, no more spooge. Starts first kick hot or cold. Don't know what market this bike was meant for when it left Spain, but I have dropped the 188 main down to a 175, replaced that needle and it's a new machine. Cheers for the resource! |
#2
|
||||
|
||||
A TM 2 stroke lever is the same, not that that is any easier to get! Plenty of aftermarket companies make them though. Re the needle, the gassers are amazing when jetted properly!
__________________
Back on a gassy! 2018 EC300! 🤘 Txt 280 07 to make me feel like a gumby again |
#3
|
||||
|
||||
Good to hear re needle btw where did you source it, just today I suggested one but I cant remember where I'd got mine and if they were a YZ or ktm option.
Gear lever are not like anything Japanese. Keep tight and there's a circlip to hold it on else out can fall off. Trust me that's vexing. Aftermarket does supply. If desperate till then, clamp the spilt end in the vice and run a hacksaw cut down the split so it doesn't bottom out.
__________________
'07 EC300 GG '14 TXT250 GG '? 496 CPI Cheetah RZ/RGV hybrid '22 765 Street Triple RS '21 XTrainer '69 Stinger T125 Suzuki '23 TRS 250RR (it's a Trials thing) |
#4
|
||||
|
||||
The Emgo shifter levers work well on the older GG bikes.
https://www.ebay.com/itm/Emgo-Steel-...4AAOSwe6xbI~yE |
#5
|
||||
|
||||
AS 3 also makes a replacement shift lever. it's aluminum, black and red anodized. Hammerhead designs used to make them for GG, but quit, which was very disappointing.
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Wanted!! Ec200 seat, radiators, switch gear, gear lever | Kendog | "Wanted to Buy" & "Want To Trade" | 2 | 10-12-2014 03:12 PM |
2013 lever cross over? | rubber Jonny | General Discussions & Announcements | 4 | 03-18-2014 05:46 AM |
Gear lever cross over -> EC 300 ? | Grogg88 | Enduro Chassis & Body | 1 | 07-01-2012 07:42 AM |
Looking for the rear brake lever replacement and Gear Lever?? | Scar13 | Enduro Chassis & Body | 11 | 03-12-2012 03:15 PM |
Clutch and brake lever cross over? | colinmc400 | Enduro Chassis & Body | 8 | 07-30-2007 12:55 PM |