|
|
|||||||
| Enduro Intake/Carburetion - 2 stroke Jetting, Reeds, Air Filters, etc. |
|
|
Thread Tools | Display Modes |
|
#1
06-21-2012, 01:21 AM
|
|||
|
|||
2012 300 issue
This has happened twice to me. Feels like a fouled plug bike wont clean out on higher rpms. Did this to me in a race for about a half an hour then cleaned out and ran good. Did the same today and let it sit and tried it and ran fine. WAS GONA CLEAN CARB AND REPLACE PLUG tomorrow but was wandering what you guys think. What plug are you guys running. I am still running stock plug. Thanks
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Powervalve issue? | SpeedyManiac | Enduro Engine - 2 stroke | 222 | 11-01-2023 07:03 PM |
| Overflow issue and bog | forgiven | Enduro Intake/Carburetion - 2 stroke | 4 | 10-05-2011 09:20 AM |
| Low down / tickover issue HELP | stevehipkiss | Enduro Intake/Carburetion - 2 stroke | 9 | 02-14-2011 09:03 AM |
| clutch issue | boostedte37 | General Discussions & Announcements | 2 | 11-09-2009 06:58 PM |
| ec 400 gearbox issue | Paul Somerville | Enduro Engine 4 stroke (including EFI & Exhaust) | 3 | 09-05-2009 10:17 AM |
Threaded Mode