|
|
|||||||
| Enduro Intake/Carburetion - 2 stroke Jetting, Reeds, Air Filters, etc. |
|
|
Thread Tools | Display Modes |
|
#1
12-20-2009, 06:30 AM
|
||||
|
||||
jetting - idle issue.
with a 42 pilot my bike idles great, and idle screw works as it should. but i get a bog off the bottom. no adjustment of air screw will remove this bog.
with a 45 pilot and airscrew at 1.5, my bike has no bog on the bottom and runs much better/stronger off idle, BUT the idle screw has almost no effect when warm. i have to wind screw in and get it basically out of the idle circuit to keep it running. if i keep the idle screw in the same position for both pilots, it idles great w/42 but will stall w/45... any suggestions??? 
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| 2001 EC300 won't idle - can't get jetting right | bexi | Enduro Intake/Carburetion - 2 stroke | 16 | 03-04-2010 10:30 PM |
| PWK replacement resolve idle, jetting issues? | socalscott | Enduro Engine - 2 stroke | 2 | 01-04-2010 12:32 PM |
| clutch issue | boostedte37 | General Discussions & Announcements | 2 | 11-09-2009 06:58 PM |
| ec 400 gearbox issue | Paul Somerville | Enduro Engine 4 stroke (including EFI & Exhaust) | 3 | 09-05-2009 10:17 AM |
| Internet Explorer 7 issue | MattR | Suggestion Box | 13 | 09-01-2007 04:05 AM |
Threaded Mode