|
Enduro Electrical & Wiring Lighting, Ignition, Wiring, Plugs, etc. |
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Test speed sensor cable?
Is it possible to use an multimeter to function test The cable? The odo used to woke up when i rotated The front wheel but it doesnt anymore.
Any other ideas on what might be causing this? Skickat från min SM-T580 via Tapatalk |
#2
|
|||
|
|||
Odo battery dead?
__________________
2003 txt250 Pro 2013 Ossa 280i |
#3
|
||||
|
||||
Do you still have the bracket with the magnet on the front wheel? On my bike it went missing within the first couple of months.
__________________
Anders "So you know, that you're over the hill when your mind makes a promise that your body can't fill" (Little Feat: Old Folks Boogie) 2015 EC200 Racing: TE bars, Rekluse Core Exp 3.0, 38mm Lectron & Ohlins S3 steering damper 2006 EC200: 2011 plastics, Rekluse Z-Start, revalved KYB forks & Scotts steering damper 1998 Bimota Supermono 1986 Duc Mille S2 1975 Guzzi sidecar hack 1961 Morini Corsaro 125 etc |
#4
|
|||
|
|||
Quote:
If you have 2 wire speed sensor then it's just usual reed switch. So it has just on-off state. If you bring magnet in front of the sensor and the multimeter starts to peeeeeeeep then the sensor is okay. |
#5
|
|||
|
|||
Just replaced it!
Quote:
Will do. |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Odo sensor on B/O | TooBadBrad | General Discussions & Announcements | 2 | 06-21-2007 07:23 PM |