|
Enduro Electrical & Wiring Lighting, Ignition, Wiring, Plugs, etc. |
|
Thread Tools | Display Modes |
#11
|
|||
|
|||
You must have the estart model. It uses a DC powered CDI, so the "single winding" wires are not connected to anything. You should get a high AC voltage on the two wires going to the rectifier. If not the stator may be bad. Clean and grease every wiring connection. Clean every ground point then try running the bike and checking AC voltage out of the stator. If it's high (50-60 volts), then check the DC voltage out of the Reg/Rect. If low you need a new Reg/Rect. If your battery voltage drops low enough the CDI may start misfiring.
Download the 2014 GG enduro manual. It has wiring diagrams in it.
__________________
2011 EC250E |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Bike won't run without battery and won't charge battery | memphis2857 | Enduro Electrical & Wiring | 3 | 04-28-2017 09:02 PM |
Battery problem? | tzsuzuki | Enduro Electrical & Wiring | 12 | 01-20-2016 10:18 AM |
I bought a 2000 xc and keep finding problem after problem | 675AZ | Enduro Engine - 2 stroke | 12 | 02-15-2013 07:25 PM |
Battery for a 07 450? | fastisbetter | Enduro Electrical & Wiring | 2 | 03-29-2011 08:06 PM |
battery power problem | GalenaGasGas | Enduro Electrical & Wiring | 3 | 04-15-2009 03:06 PM |