P3carbon fiber pipe guard Gas Gas stock pipe 08-11

[REVERUP]

Installed the P3 carbon fiber pipe guard on my 2011's stock Gas Gas pipe today.

I had the P3 on my 2008's FMF Gnarly and the fit was excellent. I found this brand is the most durable carbon fiber pipe guard going so I had no problem re ordering for my 2011.

The first thing I notice about this version for the stock Gas Gas pipe 2008-2011 after installing, its not a perfect fit but not horrible either. Some of the problem is due to the metal ridge that sticks up off of the stock pipe itself where it was pieced together in the factory. This doesn't allow the pipe guard to sit as close to flush as it would if that wasn't there. However the end of the guard nearest the head does stick out a bit and is not related with the metal ridge impeding it from being flush to the pipe.

That being said this is still is a great product and I believe it to be the toughest Carbon fiber pipe guard out there.

Roscoe

[HuskyDude]

That my friend is the best guard out there right now. Look'n good.

[GMP]

Very nice Roscoe. Next bike I think I'll try something different. I like the Hyde combo design and protection but hate the R&R. I'm thinking of a Scorpion or Utah aluminum plate, and a Flatland aluminum pipe guard. Now, add some aluminum braces to tie the two together in several places for rigidity. Maybe weld one side and bolt the other for modularity. So it will end up something like a two piece aluminum Hyde with gaps the mud can fall through.

[HuskyDude]

Agreed there is very little pipe support. I have already ripped both my silent blocks and have a bolt going though both of them from hitting logs and big rocks. It would be nice to have the pipe guard and skid plate some how tied together to prevent this.

[REVERUP]

Ya Glenn thats a good idea. Who ever comes up with a aluminum combo like the Hyde will get my attention and probably my money.

Certainly if they can design it so the vibes don't transmit through to the chassis and hitting the section that ties the two together don't cause the pipe to kink.While still being able for the mud to fall out. It would probably need some type of high temp flexible yet firm material to mate up to the pipe under the aluminum to help with that and only the strongest grade of aluminum for rigidy.

I have a real bad issue of using the exhaust as a log planer so I hope someone comes out with the ultimate combo.

Roscoe

[Krieg]

Mine fit about the same as yours. I've owned several P3's and they are by far the best as far as protecting the pipe. Nice and thick and covers a lot more of the pipe than some other brands.

[Boomhauer]

I have the p-3 on my berg and it has held up well. I must agree that it is the toughest CF I have seen thus far. Just make sure you use red lock tite on any screws.