Shift shaft play

Stamper · #1 01-18-2016, 04:47 AM

Hi all, I was changing the shift shaft seal using this method http://youtu.be/53KPK6qcaeU on my 2007 ec250 and noticed there was play on the shaft itself. A few mm in and out, no play left and right as you look at the shaft. Is this normal?

Zman · #2 01-18-2016, 07:25 AM

A few mm sounds a little high to me but it should not be an issue as long as it shifts ok. Do you have the thick metal core inner clutch cover gasket? The inner clutch cover is the inward stop for the shift shaft.

Stamper · #3 01-21-2016, 05:19 PM

Thanks for your replay, I'm unsure if I have for 2 reasons
A) I have never opened the bottom end
B) I'm not very experienced mechanically

, but I'm learning!!

Zman · #4 01-21-2016, 07:12 PM

Have you actually measured it?

Stamper · #5 01-31-2016, 05:20 PM

Sorry about the delay.
I haven't measured it, I will measure it as soon as I can.
Thanks for your reply

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Shift Shaft Assembly	mcnut	Parts	0	12-09-2014 08:58 AM
Gear shift shaft question (again)	Trailrider	Enduro Engine - 2 stroke	7	04-06-2010 09:54 AM
Shift shaft problems- continued	Trailrider	Enduro Engine - 2 stroke	10	03-17-2010 12:34 PM
Transnission shift shaft.	Trailrider	Enduro Engine - 2 stroke	15	02-28-2010 05:10 PM
Waterpump shaft end play	SpeedyManiac	Enduro Engine - 2 stroke	1	04-08-2009 09:05 AM