|
Enduro Engine 4 stroke (including EFI & Exhaust) 4 stroke engine, EFI, and exhaust discussion |
|
Thread Tools | Display Modes |
#11
|
|||
|
|||
DRZ400’s are Carbureted and not EFI. Sorry!
|
#12
|
||||
|
||||
some good info here - http://www.gasgasrider.org/forum/sho...ghlight=taiwan
|
#13
|
|||
|
|||
As regards bearings, you can search for another brand like KOYO etc. When I had Yamaha, I could buy 3 bearings (Timken) and two seals for about 14 eur instead of ~ 100 eur (offered by Yamaha dealer). Later on I foud out, that Yamaha uses (at least for XT6600) KOYO bearings as a standart.
Added 30 Jan 2018: As regards bearing for the front wheel of GG FSE 450, 2005, anyone can search the net for bearings with dimenssions: 25 x 42 x 9mm. One normal bearing (made by KOYO, TIMKEN, SKF) should cost around 12 eur. And you need 2 pcs. Last edited by expirmininkas; 01-30-2018 at 05:39 AM. Reason: Found additional information. |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
GG FSE 450 crank shaft and other parts [rebuild] | V1T0 | Enduro Engine 4 stroke (including EFI & Exhaust) | 8 | 10-27-2018 11:43 PM |
Top end rebuild | forgiven | Enduro Engine - 2 stroke | 9 | 12-05-2013 11:01 AM |
05 rebuild | brains | Enduro Suspension | 2 | 07-22-2008 08:54 AM |
Rebuild | steve | Enduro Engine - 2 stroke | 8 | 01-13-2008 03:06 PM |