HELP: 2018 GGEC300 Removing starter area conical gear and bearings

[emepher]

Recently found my bearing seized and the conical gears are not spinning. I sprayed penetrant and unseized the bearing but want to replace it. In what order are they removed and how?

[Nocams]

I used heat on the starter casting and a few firm taps on the edge of the workbench.
Came out nicely.

[fred99999au]

yep, heat around the outside of the case where the bearing lives.

I also made a tool to fit behind the pinion section of the shaft that fitted onto a slide hammer. This helped.

[eralha]

Hi, is your shaft welded to the gear? Was it come this way or did you do it after?

Thanks.

[JoseGas25]

Hello, I used this "tool". Nut and screw. I removed also the gear that is fixed with the axis but i don?t know how to explain in english, sorry.