|
Enduro Engine - 2 stroke Cylinder, Piston, Tranny, Bearings, Clutch, Pipes & Silencers, etc. |
|
Thread Tools | Display Modes |
#11
|
|||
|
|||
Thanks for the replies. I have ground the tack weld off the back of the plate and punched out the remains of the pin. I will just tack a bolt in place and make a bush to suit.
I had ordered the part from Scotties but he said he was unable to get the part from Gasgas. Hope the parts situation improves soon. Seems the new importer is only interested in moving new bikes. |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Ec 300 power valve | Jonisaacson17 | Enduro Engine - 2 stroke | 11 | 07-18-2016 09:01 PM |
Loss of power - suspect power valve | Jonny Halls | Enduro Engine - 2 stroke | 4 | 01-22-2013 09:56 AM |
power valve nut | bonkeye | Enduro Engine - 2 stroke | 4 | 10-11-2012 06:40 PM |
Is this power valve lever plate wrong? | mark250ec | Enduro Engine - 2 stroke | 2 | 09-06-2011 05:39 PM |
Power valve | bens25au | Enduro Engine - 2 stroke | 2 | 02-09-2008 11:02 PM |