|
General Discussions & Announcements General Announcements, General Questions, e.g. What bike do I buy?, etc. |
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
2012 Parts crossover
Is there one? If so where can I find it?
Thanks |
#2
|
|||
|
|||
|
#3
|
||||
|
||||
What parts are you trying to crossover?
The engine has been the same for a long time. The chassis and plastic are new 2012, they changed again slightly in 2013. The e start stuff should crossover to the 2011 e start system. Suspension changed with the chassis in 2012, linkage changed again(?) in 2013. Wheels should cross between most years, air filters are 07+ I believe. Brake pads are off a YZ, I think the numbers are 126 and 326, front and rear respectively. |
#4
|
|||
|
|||
I'm trying to find out what holeshot/launch device will fit front fork guards.Thanks.
|
#5
|
||||
|
||||
Quote:
However, CR fork guards have the same bolt pattern, well at least they have previously. KTM ones will work too apparently but I haven't tested that one. |
#6
|
|||
|
|||
Yes, but the fork guards on my bike have a ridge in the center right where the button for the launch device would mount, all others(ktm, honda ect.) I've looked at are round and smooth. Does anyone know if there is a brand that has a ridge like the GASGAS?
Thanks |
#7
|
|||
|
|||
Polisport has the ridge. It is the same fit as ktm and some crf's
Just bought a pair for a set of zoke 45's. |
#8
|
||||
|
||||
The OE GasGas fork guards can be split and removed from the forks without taking the wheel off. The KTMs have the same wrap but not the split (iirc). The Hondas don't have a back and less coverage (again iirc).
__________________
Steven Beane #275 PlusOnePerformance - Superior Service the World Over - Dearborn MI AMA District 14 (Michigan) Officer afterhourscycle.com Michigan's Beta and TM Race Headquarters |
#9
|
|||
|
|||
To find what would fit the forks I went to the Polisport website and compared part numbers, ie GasGas/KTM/CRF all had the same part number. Then just order from the least expensive website and wait.
Sorry Steve I do cheat once in awhile! |
#10
|
||||
|
||||
Still no luck sourcing a 2012 aftermarket brake pedal. I hope someone builds one soon. If i break/bend this third one I'll have to go back to the 2011 model!!!!!
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Another Parts Crossover Question | carlg | Enduro Chassis & Body | 1 | 11-28-2010 11:37 PM |
EC200 parts crossover | rupecopp | Enduro Other... | 7 | 10-20-2008 08:27 PM |
4-stroke parts crossover | Motarded1 | Enduro Engine 4 stroke (including EFI & Exhaust) | 4 | 11-05-2007 01:07 PM |
MC65 parts crossover? | bergerhag | General Discussions & Announcements | 5 | 10-07-2007 09:16 AM |
Parts Crossover idea | Phattaff | Suggestion Box | 3 | 08-21-2006 05:43 PM |