|
General Discussions & Announcements General Announcements, General Questions, e.g. What bike do I buy?, etc. |
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
'12-'13 crossovers
Has anyone had a chance to get a look at the '13 changes yet to see if its worth the coin for the changes to go on their 12's. Im interested in the seat change.
__________________
Does this rag smell like chloroform? |
#2
|
|||
|
|||
I can't imagine the seat change is all that ground breaking. I'd get the '12 and buy some '13 shrouds after you break the '12s
|
#3
|
|||
|
|||
I have a '12 but like the 1 bolt access idea to the filter.
__________________
Does this rag smell like chloroform? |
#4
|
||||
|
||||
Very easy mod to make to the seat, but you still have to contend with the battery box. Will be interesting to see how the subframe is braced now that the battery box isn't providing lateral support.
__________________
Steven Beane #275 PlusOnePerformance - Superior Service the World Over - Dearborn MI AMA District 14 (Michigan) Officer afterhourscycle.com Michigan's Beta and TM Race Headquarters |
#5
|
|||
|
|||
There is U- shaped aluminium piece in battery boxes place.
__________________
There is no such thing as bad weather! Only riding gear is improper or insufficient When it hurts you know you're allive! Gas Gas EC 300 Factory Racing 2012 - Ohlins TTX both front and rear - Rekluse Core EXP 2.0 + Rekluse clutch basket - Scalvini full exhaust system - S3 Head - Trusty adjustable PV cover That was ultimate setup for me... Now trying something else for a while... |
#6
|
|||
|
|||
The seat is already 1 bolt Or do you mean bolt through the top? If so how did you do that one
__________________
Does this rag smell like chloroform? |
#7
|
||||
|
||||
Quote:
This has been covered in another thread, but here's the short form: Sharpen the tip of a long screw and drive it up through the foam and the seat cover. Put a large washer onto a button head Phillips screw and thread it into the nut imbedded in the seat. Thread the screw in far enough to compress the foam and drop the screw head below the plane of the seat. Finish the job with a large washer and lock nut under the fender.
__________________
Steven Beane #275 PlusOnePerformance - Superior Service the World Over - Dearborn MI AMA District 14 (Michigan) Officer afterhourscycle.com Michigan's Beta and TM Race Headquarters |
#8
|
||||
|
||||
This is the photo of the crossbrace between the two subframe pieces/P1010008.jpg
|
#9
|
|||
|
|||
Quote:
Thanks mate. I will look into that one then.
__________________
Does this rag smell like chloroform? |
#10
|
|||
|
|||
Quote:
|
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
crossovers ? | wence | Enduro Chassis & Body | 8 | 03-04-2011 01:35 AM |