Anyone installed Scorpion Racing Radiator cages on a 2010 model?

[Kurdt]

I am curious as to whether anyone on this forum has installed these cages on a 2010. I'll post a few pics of my install.

[ScottyR]

I have had very poor luck with Scorpion stuff. The fit is really hit or miss.

If I was in the market for rad braces, I would wait for the Enduro Eng braces to hit the market in a couple of weeks. Their stuff always fits "right".

[aflica]

Ive got them on my Nambo , this is the 3rd set ive had , had them on my 06 , my 09 , now the 10 Nambo , Perfect fit all 3 times for me
Opps , are you talking about the Guard or the Frame ? They make more than one model
Ive got the whole gaurd with the frame cross brace ,
http://scorpionracing.ca/index.php?p...mart&Itemid=26
and it is great

[TNT Cycle]

I have the rad braces that use the stock louvers. Tricky to put on but worked fine once I stopped following the directions and did it my own way. Make the bike a bit wide but are very solid.


Cheers
Rick

[Kurdt]

I was referring to the Radiator frames. I'm going to show my install pics in the Nambotin thread because they are specific to that bike. Apparently all Nambotins have their louvers on upside down. The frames fit great and I feel confident knowing my rads aren't going to suffer in a tumble.

[WTEC]

I have them on my six days. As I recall the directions weren't very good, you have to remove the bottom outside rubber grommet all together and the rad shrouds have to be stretched a little to line up the lower bolt hole. Also, I think I had to modify the plastic louvers or swap them from one side to the other so they would clear the lower crossbar on the cages. These are very solid cages though, and have done a great job protecting the rads so far.

Wes.

[cladoo]

I put a set on NamboTrev's and they fit great!