|
Enduro Engine - 2 stroke Cylinder, Piston, Tranny, Bearings, Clutch, Pipes & Silencers, etc. |
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Top end rebuild, lots of orings?
Hi folks,
Finishing off a top end on my mates 03 300. In the gasket kit i have base gaskets, powervalve cover gaskets, reed gaskets, exhaust Orings and gasket, water pump gaskets and head o rings. There is also 7 other Orings. Where do they go? I didn't remove any this size. See pic attached Cheers |
#2
|
||||
|
||||
Looks a bit like a full gasket set..
2 x o-rings behind the counter shaft seal. 1 x o-ring on crank, clutch side. Sometimes these kits are a bit generic and will throw in a few bits to cover variances across a couple years of a similar engine. |
#3
|
||||
|
||||
Two of those medium orings look like the two I just replaced with my countershaft seal and bushing.
__________________
Edit: I am done caring why my apostrophes always turn to question marks!!!... |
#4
|
||||
|
||||
Yeah what a screw up that is. Never seen a groove that needed 2 Owings pushing on each other.
__________________
'07 EC300 GG '14 TXT250 GG '? 496 CPI Cheetah RZ/RGV hybrid '22 765 Street Triple RS '21 XTrainer '69 Stinger T125 Suzuki '23 TRS 250RR (it's a Trials thing) |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Cylinder orings | Cox76y | General Discussions & Announcements | 2 | 05-13-2016 07:07 AM |
Gnarly orings ec300 | GregS | Enduro Engine - 2 stroke | 3 | 12-01-2014 07:15 PM |
exhust springs and orings | chinesegav | United Kingdom | 9 | 05-24-2013 06:51 AM |
fork bleeder screws and orings | flybars | General Discussions & Announcements | 9 | 09-10-2012 07:28 AM |
Head orings | Brian VT | Enduro Engine - 2 stroke | 5 | 09-05-2008 11:49 AM |