Sachs fork tube caps with rebound screw

[seitz331]

Looking for a replacement Sachs 48mm Fork cap with rebound screw, just rebound screw or complete 48mm fork set. I'm not having any luck fixing my stripped rebound screw.

[Jakobi]

Sachs caps take another victim! I chased a replacement for over 6 months and ended up receiving nothing more than a couple of the small screws for the air bleed port. Good luck.

[desertgasser300]

Originally Posted by seitz331

Looking for a replacement Sachs 48mm Fork cap with rebound screw, just rebound screw or complete 48mm fork set. I'm not having any luck fixing my stripped rebound screw.

Maybe give USA Beta a call? They use the sachs on there bikes.

[twowheels]

Originally Posted by desertgasser300

Maybe give USA Beta a call? They use the sachs on there bikes.

I'll have to look at the set of Beta Sachs I have in the shop. That may be the easiest route, although I was able to repair a GasGas Sachs adjuster with silver solder and patience.

[Jakobi]

Silver solder was the fix for mine too.

[seitz331]

How do you get the solder to adhere to the brass. It didnt seam to want to want to.

Do you guys know the mm size and thread?

[twowheels]

Originally Posted by seitz331

How do you get the solder to adhere to the brass. It didnt seam to want to want to.

Do you guys know the mm size and thread?

Lots and lots of heat and patience. Don' have thread specs close by - was yours so frittered it couldn't be measured?

PlusOnePerformance