|
Enduro Engine - 2 stroke Cylinder, Piston, Tranny, Bearings, Clutch, Pipes & Silencers, etc. |
|
Thread Tools | Display Modes |
#11
|
|||
|
|||
The piston looked like some one shot a 9mm through its top. It had just burned a hole into it...
|
#12
|
||||
|
||||
But what was the reason? Always find out the why before trying to tune a mechanical issue. Otherwise you will be chasing your tail indefinitely.
__________________
Back on a gassy! 2018 EC300! 🤘 Txt 280 07 to make me feel like a gumby again |
#13
|
|||
|
|||
Melted a hole in the piston. Found the left crank seal leaking after I did the rebuild
|
#14
|
||||
|
||||
But does it still act/run lean like it did when it blew up?
|
#15
|
|||
|
|||
No that symptom was eliminated with the replacement of the crank seals.
|
#16
|
||||
|
||||
The video you posted on TT (after doing the rebuild) going up the hill sure looked like the bike was going lean.
|
#17
|
|||
|
|||
Quote:
Did you problem got away after the crank seals replacement? How did your problem starter? Mine started all of a sudden. Do you have to split the cases to replace the seals? i'm realy getting desperate with this. Thanks mate. |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
2001 Gasgas EC 300 running issues. Help needed. | Jdstep | Enduro Intake/Carburetion - 2 stroke | 6 | 04-10-2019 09:32 PM |
300 running issues | Jon250 | Enduro Intake/Carburetion - 2 stroke | 37 | 09-15-2013 05:10 PM |
Ec250 running issues | jimgsxr86 | Enduro Engine - 2 stroke | 9 | 05-03-2013 05:52 PM |
06-300 not running | davedunaway | Enduro Electrical & Wiring | 11 | 08-29-2012 09:21 AM |
03 300 not running | tophat | General Discussions & Announcements | 22 | 08-23-2011 03:51 AM |