2013 ec250 clutch master cylinder

[Dan]

Can anybody help me with what clutch master cylinder I may be able to swap/upgrade to on my bike. It currently has an ajp one fitted that is coming to the end of its life I feel so looking for some ideas on what to replace it with.
Thanks

[Pygmygod]

Why end of life?
Is it leaking or dented or rusting internally?

You may be able to put a master cylinder seal kit through it and it'll be fine again with some new fluid.

Something like this:
https://ttmoto.com.au/shop/ajp-clutc...ral-oil-9-5mm/

(Check for the right one, I just did a quick google and came up with the above result)

[Dan]

Originally Posted by Pygmygod

Why end of life?
Is it leaking or dented or rusting internally?

You may be able to put a master cylinder seal kit through it and it'll be fine again with some new fluid.

Something like this:
https://ttmoto.com.au/shop/ajp-clutc...ral-oil-9-5mm/

(Check for the right one, I just did a quick google and came up with the above result)

Bike shop fitted a new seal kit and it?s leaking after one ride

Obviously I took it back to be redone and he has said that the bore looks worn and that?s why it?s leaking so will probably leak again after this new seal

[Anders]

Originally Posted by Dan

Can anybody help me with what clutch master cylinder I may be able to swap/upgrade to on my bike. It currently has an ajp one fitted that is coming to the end of its life I feel so looking for some ideas on what to replace it with.

Thanks

You can look for a Magura. They were used in some models earlier than 2013 (e.g 2011 I believe). I think perhaps they are also used on the current models?

[cbutler]

Originally Posted by Dan

Bike shop fitted a new seal kit and it?s leaking after one ride

Obviously I took it back to be redone and he has said that the bore looks worn and that?s why it?s leaking so will probably leak again after this new seal

Im calling BS on that. I have an 01 ec 200 that I have done nothing to. I have owned it for more than five years and ride about 200 hours yearly.

[(F5)]

Like brake masters, they are only bored into bare ally. They will eventually wear the bore. Some casting may be softer or slightly porous.

[gasgasman]

The AJP master cylinders from that era have been of very low quality.

A Magura replacement will be a much better option.

[Dan]

Thanks all. I will have a look for a Magura that would fit then in case it starts to leak again.