|
|
|||||||
| Enduro Engine - 2 stroke Cylinder, Piston, Tranny, Bearings, Clutch, Pipes & Silencers, etc. |
|
|
Thread Tools | Display Modes |
|
#1
08-21-2006, 03:02 AM
|
|||
|
|||
cutting the mufler
hi all
i have been told that i can cut my stock muffler on my 05 ec250 and rivet the end cap back in with no probs ( in half) i just wont to do this for asthetics but i was told it will give it a little bit more go, because the long pipe smooths out the power. ??????????????????????????????????????????????? i have all the right tools and am happy to be a guini pig if no one has tried it on the sight.  PS what are some good mods for my bike power wise? 
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| cutting out at wot | stainlesscycle | Enduro Intake/Carburetion - 2 stroke | 13 | 07-17-2010 08:21 AM |
| FSE 450 cutting out | jack1234 | Enduro Engine 4 stroke (including EFI & Exhaust) | 1 | 04-18-2008 11:20 AM |
| Safest/Easiest Way To Carry Trail Cutting Tools... | tprnottp | General Discussions & Announcements | 1 | 01-01-2007 08:05 PM |
Threaded Mode