|
Enduro Engine - 2 stroke Cylinder, Piston, Tranny, Bearings, Clutch, Pipes & Silencers, etc. |
|
Thread Tools | Display Modes |
#1
|
||||
|
||||
Where is a piston measured 71.95 at top, middle or bottom?
As above how far down the piston is the width measured, is it at the top above the first ring or about in the middle at the widest point?
__________________
'05 Gas Gas 300 '97 Aprilia Pegaso 650 '99 KTM 200 '95 ish XR630 (died many times in Oz) |
#2
|
|||
|
|||
Above the wrist pin below the bottom ring.
__________________
jeff '00 XC250 (mine) LTS front and rear suspension, power valve cover, carb jet kit and rear chain glide, RB Designs head mod, BRP tall triple clamp, backyard foot-peg lowering conversion. '04 EC250 (the kids) (he can do his own mods haha!) |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
loose bottom marzocchi cap | noobi | Enduro Suspension | 2 | 06-06-2010 07:48 PM |
GG specify piston/bore clearance 0.06mm where is this measured? | stay_upright | Enduro Engine - 2 stroke | 0 | 07-27-2009 01:00 AM |
Measured Squish @ 1.83mm! | GG27 | Enduro Engine - 2 stroke | 9 | 06-11-2009 04:55 AM |
Ec200 Bottom end. | goody | Enduro Engine - 2 stroke | 0 | 02-13-2008 03:03 AM |