|
|
|||||||
| Enduro Chassis & Body Enduro Frame, Plastic, Brakes, Bars, Controls, wheels, tires, sprockets & gearing. |
 |
|
|
Thread Tools | Display Modes |
|
#11
01-11-2009, 09:43 AM
|
||||
|
||||
Well, today I did install 51 rear and it really is almost in. The stock tire is gently rubbing itself in the shock mudguard, which in turn is some milimeters away from the swingarm. Chain slack is exactly 30mm. I'm planning to install smaller tire anyway which I hope will solve the situation.
A 52-teeth will also fit I belive. 
|
|
#12
01-11-2009, 10:45 AM
|
||||
|
||||
|
Yes a 52 will also fit. I have a 13:50 set-up and find I need a taller 3rd and 6th gear so I am going back to 13:48 because with RBD mods I should be able to pull the gearing without any problems.
__________________
2002 Gasgas EC250 (gone not forgotten) 2012 Ktm 300xc 2001 Gasgas EC300 Lifes journey is not to arrive safely at the grave in a well preserved body, But rather to skid in sideways totally worn out shouting holy cow what a ride !!!!
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Snow Run Gearing? | eff | Enduro Chassis & Body | 15 | 02-09-2010 01:06 PM |
| Gearing Crossover | gascanuck | General Discussions & Announcements | 3 | 01-28-2009 07:25 PM |
| chain slider / chain guide crossover? | bondo | General Discussions & Announcements | 1 | 09-01-2008 09:13 PM |
| Spring length question | Bandit9 | Enduro Suspension | 4 | 06-26-2007 05:22 PM |
| Gear lever length ???? | pyroman | General Discussions & Announcements | 3 | 05-16-2007 07:59 AM |
Linear Mode
