Rieju & GasGas Legacy Riders Club Forum  

Go Back   Rieju & GasGas Legacy Riders Club Forum > GasGas Enduro Technical Forums > Enduro Engine - 2 stroke

Enduro Engine - 2 stroke Cylinder, Piston, Tranny, Bearings, Clutch, Pipes & Silencers, etc.


Reply
 
Thread Tools Display Modes
  #1  
Old 09-17-2016, 05:11 AM
gglucas gglucas is offline
Member
 
Join Date: Apr 2016
Posts: 6
Default GasGas EC 125 -09 issues

So my GasGas wasn't reving all the way out but I were still riding it, and now fue days ago it just wouldn't start at all altough it has spark and fuel. I have replaced the spark plug and the ignition coil, checked stator, flywheel, carburetor, cylinder, piston, reeds and still won't start. What could be the problem? Any help would be appriciated.


Reply With Quote


  #2  
Old 09-17-2016, 06:10 AM
Anders's Avatar
Anders Anders is offline
Gold Level Site Supporter
 
Join Date: Nov 2009
Location: Kongsberg, Norway
Posts: 1,117
Default

Check the ground connections. I had similar issues on mye 06. A bad ground connection at the ign coil was the culprit

Sent fra min E5603 via Tapatalk
__________________
Anders

"So you know, that you're over the hill when your mind makes a promise that your body can't fill" (Little Feat: Old Folks Boogie)

2015 EC200 Racing: TE bars, Rekluse Core Exp 3.0, 38mm Lectron & Ohlins S3 steering damper
2006 EC200: 2011 plastics, Rekluse Z-Start, revalved KYB forks & Scotts steering damper
1998 Bimota Supermono
1986 Duc Mille S2
1975 Guzzi sidecar hack
1961 Morini Corsaro 125
etc
Reply With Quote
  #3  
Old 09-17-2016, 07:57 AM
gglucas gglucas is offline
Member
 
Join Date: Apr 2016
Posts: 6
Default

checked the ground contact and its good, still wont start
Reply With Quote
  #4  
Old 09-17-2016, 07:58 AM
john r b's Avatar
john r b john r b is offline
Platinum Level Site Supporter
 
Join Date: Aug 2012
Location: Warrenton,Va
Posts: 956
Default

bad fuel?
__________________
'12 XC 200 TTX Sold
'15 XC 250E Sale pending
Reply With Quote
  #5  
Old 09-17-2016, 08:11 AM
RBrider's Avatar
RBrider RBrider is offline
Gold Level Site Supporter
 
Join Date: Sep 2015
Location: Fla & NC mtns
Posts: 333
Default

Crank seal on mag side.

RB
Reply With Quote
  #6  
Old 09-17-2016, 08:11 AM
Zman's Avatar
Zman Zman is offline
Platinum Level Site Supporter
 
Join Date: Apr 2010
Location: Burbs of Chicago
Posts: 1,818
Default

Have you checked the compression? Was it smoking badly last time you rode it? You should also check the crank seals. Open the ignition cover and smell for gasoline. Also smell the trans oil for the smell of gasoline. if you smell gas in either you likely have bad crank seals.
Reply With Quote
  #7  
Old 09-17-2016, 08:13 AM
gglucas gglucas is offline
Member
 
Join Date: Apr 2016
Posts: 6
Default

~1week old 98 petrol with 2,5% oil mix, should be good.
Reply With Quote
  #8  
Old 09-17-2016, 08:25 AM
Zman's Avatar
Zman Zman is offline
Platinum Level Site Supporter
 
Join Date: Apr 2010
Location: Burbs of Chicago
Posts: 1,818
Default

While you have the ignition cover off make sure the balancer is not loose. If it got loose it could have changed its timing.
Reply With Quote
  #9  
Old 09-17-2016, 08:54 AM
gglucas gglucas is offline
Member
 
Join Date: Apr 2016
Posts: 6
Default

Did a compression test and it has 9bar, should be ok? Opened the igniton cover couldn't smell any gas, just a slightly burned/corrosion kind of smell, and everything sits nice and tight there.
Reply With Quote
  #10  
Old 09-17-2016, 03:19 PM
Zman's Avatar
Zman Zman is offline
Platinum Level Site Supporter
 
Join Date: Apr 2010
Location: Burbs of Chicago
Posts: 1,818
Default

Have you tried a quick spray of starter fluid?
Reply With Quote
Reply




Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off


Similar Threads
Thread Thread Starter Forum Replies Last Post
maybe this is the cause of my issues? OMG husley Enduro Engine - 2 stroke 29 09-11-2016 06:47 AM
GasGas (Trail Tech) Speedo/Tach issues. NZ Browncoat Enduro Electrical & Wiring 4 01-12-2016 07:49 PM
gasgas issues jt633 Enduro Electrical & Wiring 7 04-11-2013 07:11 AM
02 450 FSE issues wakeymatt Enduro Engine 4 stroke (including EFI & Exhaust) 12 08-20-2012 02:33 PM
07 aftermarket issues? ktmbigfan General Discussions & Announcements 10 02-26-2007 12:16 PM




All times are GMT -5. The time now is 04:26 AM.


Powered by vBulletin® Version 3.8.6
Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.
Copyright 2009 - GasGasRider.org