|
Enduro Suspension Tuning & maintenance of Enduro forks, shocks, etc |
|
Thread Tools | Display Modes |
#1
|
||||
|
||||
Upper Shock Mount Bolt?
OK. I'm guilt of never servicing the upper mount. I'm in the process of pulling the shock and cannot loosen the upper mount bolt. I can't get a socket on it because of the shock reservoir and trying to loosen it from the bolt head isn't working.
I think I'm going to cut the nut with a Dremel cut-off wheel. Does anyone have any other suggestions?
__________________
2004 GasGas DE250 |
#2
|
||||
|
||||
im sure you tried to get a small bottle torch in there to heat it up? soak in penetrating oil? never had a single problem getting the top mount off,maybe try to tap the bolt with a hammer/drift and then try a 1/2 drive ratchet on the bolt ,with the wrench holding the nut?
|
#3
|
||||
|
||||
Did you try a thin wall socket? Its tight but works on my Sachs, and I used it it on my two Ohlins bikes including torquing the bolt on install.
A six point socket on a pneumatic impact should work as well on the other side. If everything is seized up and needs replacing anyway, I'd just drill the head off and drive the shank through. |
#4
|
||||
|
||||
I ended up drilling the shank out of the nut. Thanks for the input guys. Kind of tought spot because the bolt can only go in one way and I can only get an open end wrench on the nut. I'm going to have to torque it from the bolt end which isn't ideal.
__________________
2004 GasGas DE250 |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
08 top shock mount. | nick790 | Enduro Suspension | 3 | 03-01-2009 03:46 PM |
Bottom Shock Mount | PEB | Enduro Suspension | 6 | 10-12-2007 04:13 PM |
Upper shock mount | PEB | Enduro Suspension | 1 | 10-02-2007 11:51 AM |
Upper shock mount | PEB | Enduro Chassis & Body | 1 | 09-14-2007 02:33 PM |