|
Enduro Engine - 2 stroke Cylinder, Piston, Tranny, Bearings, Clutch, Pipes & Silencers, etc. |
|
Thread Tools | Display Modes |
#11
|
|||
|
|||
New images. I hope cleaning cylinder save us .
|
#12
|
||||
|
||||
Any pictures of the piston dome (including underside)?
With the pictures of the piston it does look like some scoring. Can you feel these marks with a finger nail? |
#13
|
|||
|
|||
I asked to my friend. He tells that he can feel 1 scretch on cylinder under side after cleaning.
|
#14
|
|||
|
|||
It looks like it's been hot a few times, and it's seen a bit of dirt of the years. I would just measure the cylinder bore, order the correct oversize piston if it even needs one, clean up the power valve and put it back together. If you're super worried about it, send off the cylinder to be replated. I've run cylinders for years and years that looked much worse than that.
|
#15
|
||||
|
||||
I agree, the cylinder looks serviceable.
__________________
04 Montesa 315R, 07 EC300, 21 KTM Erzberg 300, 21 Sherco 300 SEF-F, 23 KTM 690, 23 Rieju Mr Pro 300 |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Air Filter damage | Buysomerice | Enduro Intake/Carburetion - 2 stroke | 17 | 10-09-2014 09:34 AM |
Oops, overheated ec300, what's the damage? | solstice | Enduro Engine - 2 stroke | 15 | 01-01-2014 04:42 PM |
Ec250 Cylinder Head Bolts? | Elliker | Enduro Engine - 2 stroke | 8 | 01-24-2009 04:51 AM |
Boot damage | jhendr3702 | General Discussions & Announcements | 3 | 11-08-2008 08:35 AM |