|
Enduro Engine - 2 stroke Cylinder, Piston, Tranny, Bearings, Clutch, Pipes & Silencers, etc. |
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Ec250 Cylinder Head Bolts?
Hi im from england and have a 98 gasgas ec250 one of the cylinder head bolts har rattled looses and fallen out (allen key bolt) now there is water streamin out of the hole where the bolt was, does anyone know where i can order one of these bolts and also a sticker kit for the bike? can only seem to find new decal kits for 2002-2009 bikes here in england
thanks |
#2
|
||||
|
||||
Any automotive parts store should have bolts that you can match up.
You should replace the head gasket O-rings also. |
#3
|
||||
|
||||
Where in england are you? Any supplier of nuts bolts consumables will match you one up. I could list some in east anglia.
I have a 98 ec250. Like you say graphics are not easy to source. GG uk said that they could not supply me the graphics for the year but they could sort out something that would fit. I found some Graphic kits on Ebay motors (advance search from US only) There were some from Gofasters i did contact them about shipping to UK but as yet have had no reply. It may be the same Gofasters as the US Gas Gas web site. |
#4
|
||||
|
||||
Ok i have now received shipping info from go fasters it will be $20. I am still contacting them about the transaction.
Have a look at the item. There are others in their ebay shop http://cgi.ebay.com/ebaymotors/ws/eB...AQ:MOTORS:1123 |
#5
|
||||
|
||||
You could put on 2001 plastics and then finding graphics would be easy.
__________________
2002 Gasgas EC250 (gone not forgotten) 2012 Ktm 300xc 2001 Gasgas EC300 Lifes journey is not to arrive safely at the grave in a well preserved body, But rather to skid in sideways totally worn out shouting holy cow what a ride !!!! |
#6
|
|||
|
|||
do all the 2001 plastics fit straight on with no mods? if so that would be great
|
#7
|
|||
|
|||
The '01 and newer plastic's wont fit without changing the gas tank, '98 and '99 only
__________________
99 EC 300 |
#8
|
|||
|
|||
Update
finally got hold of a cylinder head bolt and put it in all is ok no water leaking from there anymore but now if i ride the bike and hit high revs the back wheel locks on as if the cylinde has over heated and nipped the piston? wha could be causing this? the coolent level remains full and after it has cooled down and released the piston it will kick up again?
very frustrating many thanks |
#9
|
||||
|
||||
Maybe ur water pump has failed or thermostat is not opening.
If ur engine has partially seized then u need to take your head off and check the damage to your cylinder and piston. |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
07 EC250 Cylinder head engine mount | WTEC | Enduro Engine - 2 stroke | 4 | 09-02-2009 07:12 AM |
Head bolts - no access? | eff | Enduro Engine - 2 stroke | 14 | 04-12-2008 06:43 PM |