|
|
|||||||
| Enduro Engine - 2 stroke Cylinder, Piston, Tranny, Bearings, Clutch, Pipes & Silencers, etc. |
 |
|
|
Thread Tools | Display Modes |
|
#1
12-16-2011, 11:30 PM
|
|||
|
|||
arm bolt
Took my powervalve cover off today to check for adjustment and found the bolt that attaches to the arm is very loose,should there be a nut to tighten behind the arm?Also,felt the flapper in the exhaust opening seems loose too,causing my rattle at idle.Is there an exploded view of the PV assy.that I can use,I do not have a manual.Thanks.
|
|
#2
12-16-2011, 11:41 PM
|
||||
|
||||
|
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| swingarm bolt | jimjim | Other GasGas Bikes/Quads | 7 | 11-14-2011 06:21 PM |
| Seat Bolt Tip | mcnut | Enduro Chassis & Body | 1 | 12-09-2010 11:51 AM |
| GasGas Bolt Kits? | JoeH | Enduro Chassis & Body | 5 | 07-01-2009 03:24 PM |
| Swingarm bolt | goose202 | Enduro Chassis & Body | 6 | 04-14-2009 08:01 AM |
Linear Mode
