|
Enduro Engine - 2 stroke Cylinder, Piston, Tranny, Bearings, Clutch, Pipes & Silencers, etc. |
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
EC300 Conrod
Hi
I own a 2000 EC300 which has worn crankshaft big end and main bearings. In the parts crossover list it says that a cr250 rod will fit, does anyone know what year and model will suit mine. thanks. |
#2
|
||||
|
||||
There was a previous discussion about this on the board - if you do a search, you will find it. GasGas uses the vesrah '88-'01 cr250 rod. Ron @ RB-Designs suggested using a "hot rods" rod. If you are anywhere near Portland, Oregon , I would send it to him for the rebuild. His website can be found at www.rb-designs.com.
The hot rods website is at www.hotrodproducts.com. I will update the crossover parts list to include the specific part numbers for the hot rods and vesrah '88-'01 cr250 rod. jeff webmaster GasGas Riders Club |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
2005 EC300 vs 2007 EC300 | alecsstefan | Enduro Engine - 2 stroke | 19 | 01-22-2010 01:40 AM |