|
Enduro Intake/Carburetion - 2 stroke Jetting, Reeds, Air Filters, etc. |
|
Thread Tools | Display Modes |
#1
|
||||
|
||||
Needle advice EC250
Hi all, just looking for some advice regards my carburator on EC250 1998
Removing the slide i was checking the needle and it apears to have a shiny flat spot on the tip. I assume this means that it is worn. Am i correct? The bike runs fine at all speeds (sometimes dies out at idle) The needle is a N1EC Slide #7 Jet 178 Carb PWK38 S54A3 LL Basically need to know if i have to get a new needle. If so do i change the main jet also?
__________________
1998 EC250 07 Shivers 2T racing PV Spacer FMF Gnarly |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
needle question | stainlesscycle | Enduro Intake/Carburetion - 2 stroke | 19 | 07-15-2010 09:08 AM |
CCK needle | pevs | Enduro Intake/Carburetion - 2 stroke | 2 | 02-25-2010 02:04 PM |
needle or main jet | skid jackson | Enduro Intake/Carburetion - 2 stroke | 3 | 10-30-2009 10:22 PM |
What needle is this? | bitoman | Enduro Intake/Carburetion - 2 stroke | 4 | 07-28-2009 04:26 PM |
What needle? | 2 strokes 4 life | Enduro Intake/Carburetion - 2 stroke | 8 | 08-22-2008 07:03 PM |