|
|
|||||||
| Enduro Engine - 2 stroke Cylinder, Piston, Tranny, Bearings, Clutch, Pipes & Silencers, etc. |
 |
|
|
Thread Tools | Display Modes |
|
#1
02-25-2018, 03:16 PM
|
||||
|
||||
Oil in water / water in oil
Ok had a bit of a off on my 2015 300 and snapped the plastic thermostat off , had about 10 miles to get home so took it very easy and got home , fixed problem when bike cooled down , now I've got water in oil and oil in water , is the water pump the only place where the two meet ?
__________________
Just need to test it love , only be a hour 
|
|
#3
03-01-2018, 12:15 AM
|
||||
|
||||
|
I've bought a seal kit for the bike now , can you do it from the water pump side , pick it out or do you have to take it apart more ?
__________________
Just need to test it love , only be a hour
|
|
#4
03-01-2018, 05:29 AM
|
||||
|
||||
|
You need to remove clutch side cover. Get a gasket for this cover and pump cover.
__________________
www.endurohp.eng.br Sherco ST300 2015 (Trials) https://www.instagram.com/leocm74/ Brasil!
|
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Water in headlight | 2013300 | General Discussions & Announcements | 8 | 06-02-2013 01:13 PM |
| Water in the oil | Arrhe | Enduro Engine - 2 stroke | 0 | 06-25-2011 11:54 AM |
| water in oil | gasit16 | Enduro Engine 4 stroke (including EFI & Exhaust) | 1 | 01-27-2011 10:58 PM |
| Water in oil | Mad Mike | Enduro Engine - 2 stroke | 10 | 04-20-2010 12:26 AM |
| water pump? | nhrider | Enduro Engine - 2 stroke | 17 | 12-21-2008 12:05 AM |
Linear Mode
