|
Enduro Electrical & Wiring Lighting, Ignition, Wiring, Plugs, etc. |
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
2007 ec300 No lights
Hi!
I have a 2007 ec300 which I put away a couple of months ago due to a shiny new bike & it was working perfectly, now I've dug it out to check over & prep for a mate to have a play and there are no lights at all! The garage is slightly damp (just incase there's anything known to suffer)... The regulator has had a hard life so I put a new one on for good measure & this has made no difference. I read around 35v ac on the yellow wire from the stator, same at regulator & same on the headlight connector. I can see nothing obvious, the headlight works fine off a battery. I've tried the headlight on bike without the tail light connected & vice versa with no joy. Any suggestions or any common issues to look for? Cheers- Steve |
#2
|
||||
|
||||
Check the light switch. The contacts in them can get corroded when sitting. I've had to clean more than one of them to get them to work.
__________________
WildAzzRacing YouTube channel Trail Riders of Southern AZ club AZ State Parks OHV Ambassador '11 EC250R '98 KDX220 |
#3
|
|||
|
|||
All sorted
Thanks.
Turns out it was a bad ground connection due to fresh powder coating on the frame. I should've checked that sooner but it didn't occur to me initially since all had been working fine 🙄 |
#4
|
||||
|
||||
Glad it was a simple solution!
__________________
WildAzzRacing YouTube channel Trail Riders of Southern AZ club AZ State Parks OHV Ambassador '11 EC250R '98 KDX220 |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
2006 ec300 wiring/lights | clyde34 | United Kingdom | 2 | 09-07-2023 08:51 PM |
2007 ec300 | Ud_luz | Used Bikes | 7 | 02-16-2020 01:51 AM |
All lights blinking EC300 2007 | stian | Enduro Electrical & Wiring | 24 | 08-23-2014 03:35 PM |
2005 EC300 vs 2007 EC300 | alecsstefan | Enduro Engine - 2 stroke | 19 | 01-22-2010 01:40 AM |