|
Enduro Engine - 2 stroke Cylinder, Piston, Tranny, Bearings, Clutch, Pipes & Silencers, etc. |
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
black pipes
The black pipes/tubes that come out of the p/v etc, does anyone have a good way to route these? Mine either seem to kink, or touch the pipe???
Thanks |
#2
|
||||
|
||||
I run them on the top of the frame rails coming down the bike. Seems to be fine.
__________________
2002 Gasgas EC250 (gone not forgotten) 2012 Ktm 300xc 2001 Gasgas EC300 Lifes journey is not to arrive safely at the grave in a well preserved body, But rather to skid in sideways totally worn out shouting holy cow what a ride !!!! |
#3
|
||||
|
||||
I also have them running down the frame, lightly zip tied to the down tube.
__________________
Rick 99 EC 200 06 RM 250 AMA D36 375X OTHG 375S ***Thanks for the support : Twin Air /O'Neil Racing / Race 100% / Matrix Concepts / ODI / Mika Metals |
#4
|
|||
|
|||
Smackover recomended the left one to go down the right one to go up. . I run the left down and extra long with the end folded over and ziptied. I then can pull it out remover the ziptie and let the pvalve spooge drain out. The right one I run up under the tank with a little bolt in the end of it. The bolt is tight enough to prevent any splashes from running down the tube but loose enough to let the right side exaust what it need to. My 07 that was given the once over by a factory mechanic has them both running down similar to what 2 stroke has his.
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
pipes, early vs. later years | jostby | General Discussions & Announcements | 8 | 06-16-2009 08:07 PM |
Radiator pipes | rupecopp | Enduro Chassis & Body | 5 | 01-16-2009 08:36 AM |
Where to buy Doma Pipes? | aflica | Enduro Engine - 2 stroke | 15 | 12-14-2008 08:05 AM |
pipes | Davezi | Enduro Engine - 2 stroke | 0 | 05-26-2008 10:43 AM |
Pipes and Jetting | Texas Gasser | Enduro Engine - 2 stroke | 5 | 04-23-2008 05:03 PM |