|
|
|||||||
| Enduro Intake/Carburetion - 2 stroke Jetting, Reeds, Air Filters, etc. |
 |
|
|
Thread Tools | Display Modes |
|
#1
12-07-2009, 08:59 AM
|
|||
|
|||
what about this jetting?
hi my ec 300 2004 have this setting men jet 175 . needle N1EF . 3 from top
slow jet 35 . slide 7 . end air screw 0.5 turn from full close the bike run good but not perfect thanks 
|
|
#2
12-11-2009, 07:21 AM
|
|||
|
|||
|
hi all i ask for the 35 slow jet i don't now if its the oem i think is too small
any opinion please regards
|
|
#3
12-11-2009, 07:38 AM
|
|||
|
|||
|
I would go to at least a #40 pilot and get the air screw out to 1 and 1/2. Where are you located and what are your weather conditions?
__________________
EC250 2008 Skid plate, rad braces, Fork bleeders Drz 400 Motard '03 (full spec) Yz 250 '06, KTM exc 250 '05, exc 250 '04, exc 250 '02 WRF250 '02, KDX 220 '98, DT200R '93 all sold
|
|
#4
12-11-2009, 08:28 AM
|
||||
|
||||
|
when i bought my 01 300 it had a 35 pilot in it also...
les at ltr told me that was oe jetted for leaded gas... I had never seen a pilot jet that small. 42 in mine... as gg27 says depending on where you are..
__________________
broken down over 60 slow rider..
|
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| where to go from here. jetting q. | dank | Enduro Intake/Carburetion - 2 stroke | 105 | 04-11-2011 04:25 PM |
| LTR or JD Jetting Kit | Elvis74 | Enduro Intake/Carburetion - 2 stroke | 7 | 04-08-2010 02:49 PM |
| Need help jetting an 06 EC 250 | piperpilot12w | Enduro Intake/Carburetion - 2 stroke | 3 | 11-16-2008 11:19 PM |
| jetting help for 05 300 please... | mackmack | Enduro Intake/Carburetion - 2 stroke | 5 | 09-03-2007 05:10 PM |
| 06 300 jetting | fury1 | Enduro Intake/Carburetion - 2 stroke | 1 | 07-31-2007 06:37 AM |
Linear Mode
