|
Enduro Engine - 2 stroke Cylinder, Piston, Tranny, Bearings, Clutch, Pipes & Silencers, etc. |
|
Thread Tools | Display Modes |
#11
|
|||
|
|||
Cheers lads the seal should be here tomorrow ill let you know how i get on
|
#12
|
||||
|
||||
You don't need to touch the water pump to remove the primary cover, just the relative common bolts to the water pump cover. Just drain the coolant. You do need to pull the clutch.
|
#13
|
|||
|
|||
So is it possible to remove the old one and replace it without having to take other things off?
|
#14
|
||||
|
||||
it can be done, but it is difficult to get the new one in square and seated. if it's not square and seated, it will leak.
__________________
07 ec300 was 00 xc200 now a 00 xc300. now parting out. 99 ec300 (now a pile of parts which are for sale) Stainless Cycle - Motorcycle Bolt Kits www.stainlesscycle.com |
#15
|
|||
|
|||
Brilliant cheers may turn up a little bit of nylon at work to knock it in square..
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
fse 450 br(e)ake lever $52?!! | T.Low | General Discussions & Announcements | 4 | 09-22-2009 07:25 PM |
Gear Lever crossover? | Leo | Enduro Chassis & Body | 13 | 04-17-2009 04:23 AM |
Crank Seal | kim | Enduro Engine - 2 stroke | 2 | 05-18-2008 09:41 PM |
Gear lever length ???? | pyroman | General Discussions & Announcements | 3 | 05-16-2007 07:59 AM |
00 GasGas EC300 Gear Lever | Gasser370 | Enduro Engine - 2 stroke | 20 | 03-27-2007 10:19 PM |