|
|
|||||||
| Enduro Engine - 2 stroke Cylinder, Piston, Tranny, Bearings, Clutch, Pipes & Silencers, etc. |
 |
|
|
Thread Tools | Display Modes |
|
#1
10-01-2013, 05:23 AM
|
|||
|
|||
Which base gaskets?
Hi guys, I've got an Athena top end gasket set for my 300, 2 fiber and 1 plastic. Which ones should I use for what engine characteristics and in what order? Thanks!
|
|
#2
10-01-2013, 06:14 AM
|
||||
|
||||
|
Depends. Lifting the cylinder (more gaskets) moves the power curve up in the rpm, reduces the compression ratio, and increases the squish clearance. Less does the opposite.
Beware too much compression is bad, too much squish is bad, and well, needless to say, no squish clearance is really bad.
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Gaskets? | Harry | Enduro Engine - 2 stroke | 6 | 11-17-2011 11:50 AM |
| Base Gaskets. Wondering if I should use thicker this time. | AZRickD | Enduro Engine - 2 stroke | 6 | 07-15-2011 07:37 AM |
| base gaskets | Gassey fan | Enduro Intake/Carburetion - 2 stroke | 2 | 04-29-2010 08:55 PM |
| Base Gaskets | Warwick Simpson | Enduro Engine - 2 stroke | 16 | 05-23-2009 08:16 PM |
| 125 gaskets | noobi | Enduro Engine - 2 stroke | 0 | 04-23-2009 05:08 PM |
Linear Mode
